Standard Active Last Updated: Sep 07, 2023 Track Document
ASTM D6754/D6754M-23

Standard Specification for Ketone Ethylene Ester Based Sheet Roofing

Standard Specification for Ketone Ethylene Ester Based Sheet Roofing D6754_D6754M-23 ASTM|D6754_D6754M-23|en-US Standard Specification for Ketone Ethylene Ester Based Sheet Roofing Standard new BOS Vol. 04.04 Committee D08
$ 61.00 In stock
ASTM International

Abstract

This specification covers flexible sheet made from ketone ethylene ester (KEE) as the primary polymer intended for use in single ply roofing membrane exposed to the weather. The sheet shall be reinforced with fabric. The sheet shall be formulated from the appropriate polymers and other compounding ingredients. To make seam and repairs, the sheet shall be capable of being bonded watertight to itself during the design service life of the sheets. Overall thickness; thickness, coating over reinforcement optical method; breaking strength; elongation at break; tearing strength; linear dimensional change; fabric adhesion; heat aging; after heat aging low temperature bend; low temperature bend; water absorption; factory seam strength; hydrostatic resistance; static puncture test; accelerated weathering test; fungi resistance; abrasion test; and dimension tests shall be performed to conform with the requirements specified.

Scope

1.1 This specification covers flexible sheet made from ketone ethylene ester (KEE) as the primary polymer intended for use in single-ply roofing membrane exposed to the weather. The sheet shall be reinforced with fabric.

1.2 In-place roof system design criteria, such as fire resistance, field-seaming strength, material compatibility, uplift resistance, in-situ shrinkage, among others, are factors that must be considered but are beyond the scope of this specification.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4 The following precautionary caveat pertains to the test methods portion only, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.04
Developed by Subcommittee: D08.18
Pages: 3
DOI: 10.1520/D6754_D6754M-23
ICS Code: 91.060.20