Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM C587-97e1

Standard Specification for Gypsum Veneer Plaster

Standard Specification for Gypsum Veneer Plaster C0587-97E01 ASTM|C0587-97E01|en-US Standard Specification for Gypsum Veneer Plaster Standard new BOS Vol. 04.01 Committee C11
$ 66.00 In stock


1.1 This specification covers calcined gypsum mixed at the mill with other ingredients to control working quality and setting time; specifically designed as a veneer plaster to be applied over gypsum base for veneer plasters, masonry or concrete surfaces to a maximum thickness of 1/4 in. (6.4 mm) providing a surface ready for decoration.

Note 1—Specification C 843 contains application procedures for gypsum veneer plaster.

1.2 This specification covers test methods for determining the physical properties of gypsum veneer plasters and sets forth minimum requirements that must be met.

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI (metric) values given in parentheses are approximate and are provided for information purposes only.

1.4 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes shall not be considered as requirements of the standard.

1.5 The following safety hazards caveat applies only to the Test Methods portion, Section 5 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 04.01
Developed by Subcommittee: C11.01
Pages: 2
DOI: 10.1520/C0587-97E01
ICS Code: 91.100.10