Standard Historical Last Updated: Apr 30, 2014 Track Document
ASTM B467-09

Standard Specification for Welded Copper-Nickel Pipe

Standard Specification for Welded Copper-Nickel Pipe B0467-09 ASTM|B0467-09|en-US Standard Specification for Welded Copper-Nickel Pipe Standard new BOS Vol. 02.01 Committee B05
$ 83.00 In stock

Significance and Use

For purposes of determining compliance with the specified limits for requirements of the properties listed in the following table, and observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29.

PropertyRounded Unit for Observed or Calculated Value
Chemical compositionnearest unit in the last right-hand place of figures of the specified limit
Tensile strength
Yield strength
nearest ksi [nearest MPa up to 10 ksi, incl, nearest 5 MPa over 10 ksi]
Elongationnearest 1 %

Abstract

This specification covers welded copper-nickel alloy pipes produced from Copper Alloy UNS Nos. C70600 and C71500 for general engineering applications. Pipes may be produced in any one of the following tempers: as-welded from annealed sheets, strips, or plates (WM50); as-welded from cold-worked sheets, strips, or plates (WM00, WM01, WM02, and so forth); welded and annealed (WO50); welded, light cold drawn (WR00) or hard cold drawn (WR04), and stress relieved; or fully finished as annealed, light drawn (WH00) or hard drawn (WH04), and stress relieved. Products shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (outside diameter, specific and stock lengths, wall thickness, squareness of cut, and roundness), mechanical (tensile and yield strengths, and elongation), and chemical composition requirements. Specimens shall also undergo nondestructive tests such as radiographic examination, eddy-current test, and hydrostatic test.

Scope

1.1 This specification establishes the requirements for welded copper-nickel alloy pipe for general engineering purposes. The following alloys are covered:

Copper Alloy
UNS No.
Type of Metal
C7060090-10 copper-nickel
C7062090-10 copper-nickel
(Modified for Welding)
C7150070-30 copper-nickel
C7152070-30 copper-nickel
(Modified for Welding)

1.2 UnitsThe values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems could result in nonconformance with the specification.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.01
Developed by Subcommittee: B05.04
Pages: 6
DOI: 10.1520/B0467-09
ICS Code: 77.150.30