Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM A600-92a(2004)

Standard Specification for Tool Steel High Speed

Standard Specification for Tool Steel High Speed A0600-92AR04 ASTM|A0600-92AR04|en-US Standard Specification for Tool Steel High Speed Standard new BOS Vol. 01.05 Committee A01
$ 91.00 In stock

Abstract

This specification covers seven tungsten-type (types T1, T2, T4, T5, T6, T8, and T15) and nineteen molybdenum-type high-speed steels (types M1, M2, M3, M4, M6, M7, M10, M30, M33, M34, M36, M41, M42, M43, M44, M46, M47, M48, and M62) in the form of annealed, hot-rolled bars, forgings, plate, sheet, or strip, and annealed, cold-finished bars or forgings used primarily in the fabrication of tools. Two intermediate high speed tool steels designated as M50 and M52 are also covered. Unless otherwise specified, material shall be made by an electric melting process. A chemical analysis of each heat of steel shall be made to determine the percentage of the elements specified (including carbon, manganese, phosphorus, sulfur, silicon, chromium, vanadium, tungsten, molybdenum, and cobalt) and these values shall conform to the requirements as to the prescribed chemical composition. Requirements for: (1) heat treatment such as austenitizing, quenching, and tempering, (2) hardness testing (3) macrostructure and macroetch standard for porosity and ingot pattern, and (4) decarburization determination are detailed. The maximum Brinell hardness and minimum Rockwell C hardness for the tool steels are given.

Scope

1.1 This specification covers tungsten-type and molybdenum-type high-speed steels available as annealed, hot-rolled bars, forgings, plate, sheet, or strip, and annealed, cold-finished bars or forgings used primarily in the fabrication of tools.

1.2 Seven types of tungsten high-speed tool steels designated T1, T2, etc., seventeen types of molybdenum high-speed tool steels designated M1, M2, etc., and two intermediate high speed steels designated as M50 and M52 are covered. Selection will depend upon design, service conditions, and mechanical properties.

1.3 The term "high-speed steel" is described and its minimum requirements are covered in the Annex.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.05
Developed by Subcommittee: A01.29
Pages: 14
DOI: 10.1520/A0600-92AR04
ICS Code: 77.140.10