Standard Historical Last Updated: May 16, 2011 Track Document
ASTM B644-05

Standard Specification for Copper Alloy Addition Agents

Standard Specification for Copper Alloy Addition Agents B0644-05 ASTM|B0644-05|en-US Standard Specification for Copper Alloy Addition Agents Standard new BOS Vol. 02.01 Committee B05
$ 73.00 In stock

Abstract

This specification establishes the requirements for copper nickel, ferro copper, phosphor copper, and silicon copper master alloys in ingot, shot, and waffle form to be used as addition agents for cast and wrought alloys. Any material may be used which, when melted, will form an alloy of the required composition. Any manufacturing process may be used that will yield a product uniform in composition and free of defects of a nature that would render the product unsuitable for the intended application. The product in final form shall conform to the chemical composition requirements for the specified alloy. The sample for chemical analysis shall be done as specified. Composition shall be determined as the average of results from at least two replicate determinations for each element specified. For purposes of determining compliance with the specified limits for chemical composition, an observed or calculated value shall be rounded appropriately.

Scope

1.1 This specification establishes the requirements for copper nickel, ferro copper, phosphor copper, and silicon copper master alloys in ingot, shot, and waffle form to be used as addition agents for cast and wrought alloys.

1.2 Inch-pound units are the standard. SI units given in parenthesis are for information only.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.01
Developed by Subcommittee: B05.05
Pages: 4
DOI: 10.1520/B0644-05
ICS Code: 25.160.20