ASTM D7003 / D7003M - 03(2013)e1

    Standard Test Method for Strip Tensile Properties of Reinforced Geomembranes

    Active Standard ASTM D7003 / D7003M | Developed by Subcommittee: D35.10

    Book of Standards Volume: 04.13

      Format Pages Price  
    PDF 2 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $46.00   ADD TO CART

    Significance and Use

    4.1 This test method evaluates strip tensile properties of reinforced geomembranes for the purposes of quality control, quality assurance and research. In order to evaluate the full contribution of the reinforcement, testing is performed parallel to the directions of reinforcement. This test method is an index test and is not intended for design purposes.

    1. Scope

    1.1 This test method is used to measure the strip tensile properties of reinforced geomembranes.

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D76/D76M Specification for Tensile Testing Machines for Textiles

    D4354 Practice for Sampling of Geosynthetics and Rolled Erosion Control Products(RECPs) for Testing

    D4439 Terminology for Geosynthetics

    ICS Code

    ICS Number Code 59.080.70 (Geotextiles)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D7003_D7003M-03R13E01

    Citation Format

    ASTM D7003 / D7003M-03(2013)e1, Standard Test Method for Strip Tensile Properties of Reinforced Geomembranes, ASTM International, West Conshohocken, PA, 2013,

    Back to Top