ASTM D516-90(1995)e1

    Standard Test Method for Sulfate Ion in Water


      Format Pages Price  
    PDF 4 $52.00   ADD TO CART


    1. Scope

    1.1 This turbidimetric test method covers the determination of sulfate in water in the range from 1 to 40 mg/L of sulfate ion (SO 4).

    1.2 This test method was used successfully with drinking, ground, and surface waters. It is the user's responsibility to ensure the validity of this test method for waters of untested matrices.

    1.3 Former gravimetric and volumetric test methods have been discontinued. Refer to Appendix X1 for historical information.

    1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1066 Practice for Sampling Steam

    D1129 Terminology Relating to Water

    D1193 Specification for Reagent Water

    D2777 Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water

    D3370 Practices for Sampling Water from Closed Conduits

    D4327 Test Method for Anions in Water by Suppressed Ion Chromatography

    D5810 Guide for Spiking into Aqueous Samples

    D5847 Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis

    E60 Practice for Analysis of Metals, Ores, and Related Materials by Spectrophotometry

    E275 Practice for Describing and Measuring Performance of Ultraviolet and Visible Spectrophotometers


    ICS Code

    ICS Number Code 13.060.50 (Examination of water for chemical substances)

    UNSPSC Code

    UNSPSC Code 47101516(Turbidimeters)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0516-90R95E01

    Citation Format

    ASTM D516-90(1995)e1, Standard Test Method for Sulfate Ion in Water, ASTM International, West Conshohocken, PA, 2002, www.astm.org

    Back to Top