ASTM D1072-06(2012)

    Standard Test Method for Total Sulfur in Fuel Gases by Combustion and Barium Chloride Titration


      Format Pages Price  
    PDF 6 $60.00   ADD TO CART


    1. Scope

    1.1 This test method is for the determination of total sulfur in combustible fuel gases, when present in sulfur concentrations between approximately 25 and 700 mg/m3 (1 to 30 grains per 100 cubic feet). It is applicable to natural gases, manufactured gases, mixed gases, and other miscellaneous gaseous fuels.

    1.2 The values stated in inch-pound units are to be regarded as standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1193 Specification for Reagent Water


    ICS Code

    ICS Number Code 75.160.30 (Gaseous fuels)

    UNSPSC Code

    UNSPSC Code 15111500(Gaseous fuels)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1072-06R12

    Citation Format

    ASTM D1072-06(2012), Standard Test Method for Total Sulfur in Fuel Gases by Combustion and Barium Chloride Titration, ASTM International, West Conshohocken, PA, 2012, www.astm.org

    Back to Top