ASTM B379-99
Standard Specification for Phosphorized Coppers-Refinery Shapes
SUPERSEDED (click for Active standard)
| Format | Pages | Price | ||
 |
5 | $62.00 |  ADD TO CART |
Active (view current version of standard)
1. Scope
1.1 This specification establishes the requirements for phosphorized copper wire bars, billets, and cakes.
Note 1-Wire bars furnished under this specification do not conform in dimensions with that furnished under Specification B5.1.2 The values in inch-pound units are the standard. SI values given in parentheses are for information only.
1.3 The following hazard caveat applies to Sections 14.2 and 14.3 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B5 Specification for High Conductivity Tough-Pitch Copper Refinery Shapes
B193 Test Method for Resistivity of Electrical Conductor Materials
B224 Classification of Coppers
B577 Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper
B846 Terminology for Copper and Copper Alloys
E3 Guide for Preparation of Metallographic Specimens
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E53 Test Method for Determination of Copper in Unalloyed Copper by Gravimetry
E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)
E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
ICS Code
ICS Number Code 77.150.30 (Copper products)
UNSPSC Code
UNSPSC Code 30262200(Copper bars); 60122702(Copper shapes)
Referencing This Standard
| Link Here | |||
| Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/B0379-99
Citation Format
ASTM B379-99, Standard Specification for Phosphorized Coppers-Refinery Shapes, ASTM International, West Conshohocken, PA, 1999, www.astm.org
Back to Top