This consumer safety specification deals with the requirements for the design and performance of toddler beds. It also contains requirements for labeling and instructional material. This consumer safety specification is intended to minimize incidents to children resulting from normal use and reasonably foreseeable misuse of toddler beds. It does not address incidents resulting from alteration or unreasonable misuse. Materials shall be tested and shall conform to requirements of small parts, paint and surface coating, scissoring, shearing, and pinching, protective components, openings, labeling, corner post extensions, mattress retention, mattress support system, mattress support system attachment to end structures, guardrails, end structures, partially bounded openings, and permanency of labels and warnings.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This consumer safety specification covers requirements for the design and performance of toddler beds. It also contains requirements for labeling and instructional material.
1.2 This consumer safety specification is intended to minimize incidents to children resulting from normal use and reasonably foreseeable misuse of toddler beds. It does not address incidents resulting from alteration or unreasonable misuse.
1.3 For the purposes of this consumer safety specification, a toddler bed is a bed that is sized to accept a full-size crib mattress and is intended for use by a child not less than 15 months of age and who weighs no more than 50 lb (27.7 kg).
1.4 No toddler bed produced after the approval date of this consumer safety specification shall indicate compliance with this specification, either by label or by other means, unless it conforms to all the requirements contained herein.
1.5 This consumer safety specification includes the following sections:
|Referenced Documents||Section 2|
|Calibration and Standardization||Section 4|
|General Requirements||Section 5|
|Performance Requirement||Section 6|
|Test Methods||Section 7|
|Marking and Labeling ||Section 8|
|Instructional Literature||Section 9|
1.6 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.7 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D3359 Test Methods for Measuring Adhesion by Tape Test
D3574 Test Methods for Flexible Cellular Materials--Slab, Bonded, and Molded Urethane Foams
bed; toddler; Children's furniture; Consumer safety specifications; Beds; Toddler beds
ICS Number Code 97.190 (Equipment for children)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]