ASTM D7871 - 13

    Standard Test Method for Analysis of Cyclohexane by Gas Chromatography (Effective Carbon Number)

    Active Standard ASTM D7871 | Developed by Subcommittee: D16.01

    Book of Standards Volume: 06.04


    Buy Standard (PDF)
    6 pages
    $42.00
    Buy Standard (Print)
    6 pages
    $42.00


    ASTM D7871

    Significance and Use

    5.1 This test method is suitable for setting specifications on the materials referenced in Table 1 and for use as an internal quality control tool where cyclohexane is produced or is used in a manufacturing process. It may also be used in development or research work involving cyclohexane.

    5.2 This test method is useful in determining the purity of cyclohexane with normal impurities present. If extremely high boiling or unusual impurities are present in the cyclohexane, this test method would not necessarily detect them and the purity calculation would be erroneous.

    1. Scope

    1.1 This test method covers the determination of the purity of cyclohexane by gas chromatography.

    1.2 This test method has been found applicable to the measurement of impurities such as those found in Table 1, which are impurities that may be found in cyclohexane. The impurities can be analyzed over a range of 1 to 400 mg/kg by this method, but may be applicable to a wider range.

    1.3 The limit of detection is 1 mg/kg.

    1.4 In determining the conformance of the test results using this test method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E29.

    1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Section 8.


    ICS Code

    ICS Number Code 71.080.10 (Aliphatic hydrocarbons)

    UNSPSC Code

    UNSPSC Code 41115710(Gas chomatography GC columns)


    DOI: 10.1520/D7871

    ASTM International is a member of CrossRef.

    ASTM D7871

    Citing ASTM Standards
    Back to Top