This classification establishes an orderly grouping of insulating firebrick to provide group identifications for use by those producing or purchasing these materials. The group identification number is not meant to specifically designate the maximum service temperature although the number times 100 does approximate the temperature (in degrees Fahrenheit) to be used to check the reheat change and can be used as a guide for relative temperature stability. The bulk density limits the weight per unit volume for any group as sold, but is not meant to be used for detailed engineering calculations.

1. Scope

1.1 This classification covers heat insulating material known as insulating firebrick. This material is suitable for lining certain kinds of industrial furnaces.

Note 1—Insulating materials for use below 1000°F (538°C) are covered by ASTM Committee C-16 on Thermal Insulation.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

C134 Test Methods for Size, Dimensional Measurements, and Bulk Density of Refractory Brick and Insulating Firebrick

C210 Test Method for Reheat Change of Insulating Firebrick

Keywords

bulk density; insulating firebrick; refractories; reheat change;

ICS Code

ICS Number Code 81.080 (Refractories)

Citing ASTM Standards

[Back to Top]