Standard Historical Last Updated: Jan 23, 2013 Track Document
ASTM D6601-02(2008)

Standard Test Method for Rubber Properties—Measurement of Cure and After-Cure Dynamic Properties Using a Rotorless Shear Rheometer

Standard Test Method for Rubber PropertiesMeasurement of Cure and After-Cure Dynamic Properties Using a Rotorless Shear Rheometer D6601-02R08 ASTM|D6601-02R08|en-US Standard Test Method for Rubber PropertiesMeasurement of Cure and After-Cure Dynamic Properties Using a Rotorless Shear Rheometer Standard new BOS Vol. 09.01 Committee D11
$ 66.00 In stock

Significance and Use

This test method is used to determine the vulcanization characteristics of (vulcanizable) rubber compounds under selected test conditions of strain and frequency which do not significantly affect the cured dynamic properties. In the same test, this test method also will measure the dynamic properties of the vulcanizate at temperatures significantly below the cure temperature. These lower temperature measurements are necessary in order to more effectively relate to rubber product service conditions.

This test method may be used for quality control in rubber manufacturing processes and for research and development testing of rubber compounds containing curatives. This test method also may be used for evaluating cure and dynamic property differences resulting from the use of different compounding ingredients.

For additional information regarding the significance of dynamic testing of vulcanized rubber, the reader may wish to reference Guide D 5992.

Scope

1.1 This test method covers the use of a rotorless oscillating shear rheometer for measuring after cure dynamic properties at predetermined temperature(s) below the cure temperature.

1.2 Specified cure conditions that approximate a static cure also are covered to minimize effects on cured rubber compound dynamic properties. This test method is not intended to replace Test Method D 5289.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 Warning—Compounds based on silicone or fluoroelastomers may have high levels of thermal contraction or poor adhesion to the dies when cooled after the cure portion of this test method, causing slippage during strain sweeps. If this occurs, the results will not be reliable.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 09.01
Developed by Subcommittee: D11.14
Pages: 4
DOI: 10.1520/D6601-02R08
ICS Code: 83.060