SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|8||$54.00||  ADD TO CART|
1.1 This specification covers austenitic and age-hardenable stainless steel round spring wire intended especially for the manufacture of springs.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 Unless the order specifies an “M” designation, the material shall be furnished to inch-pound units.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A555/A555M Specification for General Requirements for Stainless Steel Wire and Wire Rods
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
Society of Automotive Engineers StandardJ 1086 Numbering Metals and Alloys
ICS Number Code 77.140.25 (Spring steels)
UNSPSC Code 31152203(Stainless steel wire)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A313 / A313M-10e1, Standard Specification for Stainless Steel Spring Wire, ASTM International, West Conshohocken, PA, 2010, www.astm.orgBack to Top