F16.02 Jurisdiction Page

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

Subcommittee F16.02 on Steel Bolts, Studs and Nuts

Matching Standards Under the Jurisdiction of F16.02 by Status

Active 18 matching standards

A307-21 Standard Specification for Carbon Steel Bolts, Studs, and Threaded Rod 60 000 PSI Tensile Strength
A354-17e2 Standard Specification for Quenched and Tempered Alloy Steel Bolts, Studs, and Other Externally Threaded Fasteners
A394-08(2015) Standard Specification for Steel Transmission Tower Bolts, Zinc-Coated and Bare
A449-14(2020) Standard Specification for Hex Cap Screws, Bolts and Studs, Steel, Heat Treated, 120/105/90 ksi Minimum Tensile Strength, General Use
A489-18e1 Standard Specification for Carbon Steel Eyebolts
A563/A563M-21ae1 Standard Specification for Carbon and Alloy Steel Nuts (Inch and Metric)
A574-21 Standard Specification for Alloy Steel Socket-Head Cap Screws
F432-19 Standard Specification for Roof and Rock Bolts and Accessories
F541-12(2020) Standard Specification for Alloy Steel Eyebolts
F835-23 Standard Specification for Alloy Steel Socket Button, Low and Flat Countersunk Head Cap Screws
F912-11(2017) Standard Specification for Alloy Steel Socket Set Screws
F1554-20 Standard Specification for Anchor Bolts, Steel, 36, 55, and 105-ksi Yield Strength
F2482/F2482M-21 Standard Specification for Load-Indicating Externally Threaded Fasteners
F2882/F2882M-17 Standard Specification for Screws, Alloy Steel, Heat Treated, 170 ksi and 1170 MPa Minimum Tensile Strength (Inch and Metric)
F3043-15 Standard Specification for “Twist Off” Type Tension Control Structural Bolt/Nut/Washer Assemblies, Alloy Steel, Heat Treated, 200 ksi Minimum Tensile Strength
F3111-16 Standard Specification for Heavy Hex Structural Bolt/Nut/Washer Assemblies, Alloy Steel, Heat Treated, 200 ksi Minimum Tensile Strength
F3125/F3125M-23 Standard Specification for High Strength Structural Bolts and Assemblies, Steel and Alloy Steel, Heat Treated, Inch Dimensions 120 ksi and 150 ksi Minimum Tensile Strength, and Metric Dimensions 830 MPa and 1040 MPa Minimum Tensile Strength
F3148-17a Standard Specification for High Strength Structural Bolt Assemblies, Steel and Alloy Steel, Heat Treated, 144ksi Minimum Tensile Strength, Inch Dimensions

Withdrawn, Replaced 29 matching standards

Copyright © 1996 - 2023 ASTM. All Rights Reserved. ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA, 19428-2959 USA