Loading...
Using Artificial Intelligence (AI) on ASTM standards and related intellectual property is prohibited. Violations will result in suspension of access.
Nov 02, 2025
ASTM International’s additive manufacturing technologies committee (F42) is developing a proposed standard that will allow manufacturers to maximize the strength and quality of parts produced using the polymer additive manufacturing (AM) extrusion process.
According to ASTM member Rick Cole - a research officer at the National Research Council of Canada (NRC) and expert in composites manufacturing - the proposed standard (WK81710) will be used to assess the inter-layer weld in shear through a test that has been shown to provide repeatable results.
“It has been shown that the weakest areas of polymer AM parts produced using an extrusion process are formed between layers as material is deposited, also known as the inter-layer weld,” says Cole. “The properties of this weld have been found to be difficult to measure repeatably, for example, using tensile tests.”
According to Cole, the proposed standard will provide data that will be useful to part designers, manufacturing process developers, and quality assurance personnel.
“The good repeatability of the test in this proposed standard will allow users to fine-tune their manufacturing process, including setting printing parameters, to optimize the strength of printed parts,” says Cole. “Quality assurance personnel should find the test useful to verify the quality of a printing process on an ongoing basis.”
“Increased use of the polymer AM extrusion process described in this proposed standard will help to eliminate the energy and materials required to manufacture tooling needed for traditional processes, such as injection molding,” says Cole. “The polymer AM process allows for the production of complex plastic parts without the use of tooling.”
ASTM welcomes participation in the development of its standards. JOIN ASTM.
U.N. Sustainable Development Goals Supported:
January / February 2026
