Journal Published Online: 10 August 2018
Volume 47, Issue 6

A Novel Tribometer Designed to Evaluate Geological Sliding Contacts Lubricated by Drilling Muds

CODEN: JTEVAB

Abstract

Great interest in improving lubricity, or reducing friction, of drilling muds used for horizontal oil well drilling is motivated by increasing the horizontal reach that can be attained by a single drilling site. However, there are a limited number of commercially available devices that can be used to evaluate novel drilling mud solutions under sliding conditions that accurately replicate those encountered in the field, and those that are available are often prohibitively expensive. Here, the design of a low-cost lubricity meter, or tribometer, is documented. The purpose-built tribometer is capable of varying rotating speeds, applied normal loads, temperature, and counter surface materials. In particular, the counter surface of the tribometer can be either a steel surface, as is often used in the industrial lubricity meters available in corporate laboratories, or a geological core specimen taken from the drill site. The novel instrument was then used to evaluate four commercially available water-based drilling fluid lubricant additives, dissolved in distilled water, for both a steel-on-steel contact and a steel-on-rock contact. The steel-on-steel contact shows that the tribometer replicates the results of tests typically conducted in drilling fluid labs, thus verifying the performance of the newly developed tribometer. Additional results show that the friction and performance of the lubricant depend significantly on the materials used: steel-on-steel contacts show much lower friction than steel-on-sandstone contact. Finally, a weak dependence on the applied load is shown for a number of lubricant additives examined.

Author Information

Egberts, Philip
Department of Mechanical and Manufacturing Engineering, Schulich School of Engineering, University of Calgary, Calgary, AB, Canada
Simin, Nicholas
Department of Mechanical and Manufacturing Engineering, Schulich School of Engineering, University of Calgary, Calgary, AB, Canada
Wong, Calvin
Department of Mechanical and Manufacturing Engineering, Schulich School of Engineering, University of Calgary, Calgary, AB, Canada
Czibor, Jan
Department of Mechanical and Manufacturing Engineering, Schulich School of Engineering, University of Calgary, Calgary, AB, Canada
Ewanchuk, Curtis
Department of Mechanical and Manufacturing Engineering, Schulich School of Engineering, University of Calgary, Calgary, AB, Canada
Park, Simon
Department of Mechanical and Manufacturing Engineering, Schulich School of Engineering, University of Calgary, Calgary, AB, Canada
Pages: 11
Price: $25.00
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Stock #: JTE20170468
ISSN: 0090-3973
DOI: 10.1520/JTE20170468