Journal Published Online: 24 October 2018
Volume 48, Issue 4

Study on Dimension Measurement for Gas Guide Groove of Gun Barrel

CODEN: JTEVAB

Abstract

An automatic measurement system based on the stationary wavelet transform (SWT) of vibration signal is developed to obtain the depth and width of gas guide grooves in the gun barrel. The system consists of the programmable logic controller module used to control the motions of system components, a mechanical apparatus used to fix the gun barrel and position the transducer, and a measurement device used to capture and analyze the measured data. With the SWT, the interference noise, baseline wander, and interference harmonics are successively eliminated from the captured displacement signal. Afterwards, the peak and valley points are detected out, which, respectively, represent the information of groove depth and of groove width. Finally, the dimensions of the gas guide groove are determined according to the points detected out and the calibration information. In the experiment, the steps of data processing are provided in detail, and the analysis results show that the measuring error is less than 3 %, which can meet the actual requirements.

Author Information

Liu, Xiaofeng
The State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing, People’s Republic of China
Yang, Kangjun
The State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing, People’s Republic of China
Bo, Lin
The State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing, People’s Republic of China
Pages: 15
Price: $25.00
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Stock #: JTE20160622
ISSN: 0090-3973
DOI: 10.1520/JTE20160622