Journal Published Online: 01 September 2000
Volume 23, Issue 3

Assessment of Localized Deformations in Sand Using X-Ray Computed Tomography



The internal fabric and localized deformation patterns of triaxial sand specimens were investigated using computed tomography (CT). Three displacement-controlled, conventional, drained axisymmetric (triaxial) experiments were conducted on dry Ottawa sand specimens at very low effective confining stresses (0.05, 0.52, and 1.30 kPa) in a microgravity environment aboard the Space Shuttle during the NASA STS-79 mission. CT scanning was performed on these flight specimens, as well as on an uncompressed specimen and a specimen tested in a terrestrial laboratory at 1.30 kPa effective confining stress. CT demonstrated high accuracy in detecting specimen inhomogeneity and localization patterns. Formation of deformation patters is dependent on the effective confining stress and gravity. Multiple symmetrical radial shear bands were observed in the specimens tested in a microgravity environment. In the axial direction, two major conical surfaces were developed. Nonsymmetrical spatial deformation was observed in the 1-G specimen. Analysis tools were developed to quantify the spatial density change. Void ratio variation within and outside the shear bands is calculated and discussed.

Author Information

Alshibli, KA
University of Alabama, Huntsville, Huntsville, AL
Sture, S
University of Colorado at Boulder, Boulder, CO
Costes, NC
University of Colorado at Boulder, Huntsville, AL
Frank, ML
Reisz Engineering, Huntsville, AL
Lankton, MR
University of Colorado at Boulder, Boulder, CO
Batiste, SN
University of Colorado at Boulder, Boulder, CO
Swanson, RA
University of Colorado at Boulder, Boulder, CO
Pages: 26
Price: $25.00
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Stock #: GTJ11051J
ISSN: 0149-6115
DOI: 10.1520/GTJ11051J