Journal Published Online: 01 December 1984
Volume 7, Issue 4

Suggested Method for Estimating the In-Situ Modulus of Deformation of Rock Using the NX-Borehole Jack

CODEN: GTJODJ

Abstract

The NX-borehole jack is a widely used tool for estimating the deformability of rock masses in-situ. It applies unidirectional pressure to the walls of a rock borehole by means of two steel platens. In theory, the analysis of test data is straightforward: the modulus estimate requires a record of applied hydraulic pressure versus borehole diameter change, and a knowledge of the rock's Poisson's ratio. In practice, the above procedure, using the original theoretical formula, frequently has resulted in computing a material modulus that was demonstrably too low.

Today, it is finally understood how one or more of the following factors can provide a low modulus estimate: (1) the longitudinal outward bending of the jack plates which gives artificially high readings of the displacement gages and (2) the mismatch between borehole and jack platen radii, which would negate the full platen/rock contact assumed in the original analysis, and (3) tensile cracking of the intact rock or tensile opening of natural joints around the borehole under the jack.

The detailed discussion of the theoretical developments is contained in a separate paper, which should be a complement to this draft. This document outlines a suggested procedure for testing with the NX-jack, and analyzing the test results in a medium which is assumed to be isotropic, linear, clastic, and homogeneous.

Author Information

Heuze, FE
Geotechnical Group, and Manager of Unconventional Gas Program, Lawrence Livermore National Laboratory, Livermore, CA
Pages: 6
Price: $25.00
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Stock #: GTJ10503J
ISSN: 0149-6115
DOI: 10.1520/GTJ10503J