Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM G105-02

Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests

Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests G0105-02 ASTM|G0105-02|en-US Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests Standard new BOS Vol. 03.02 Committee G02
$ 75.00 In stock

Scope

1.1 This test method covers laboratory procedures for determining the resistance of metallic materials to scratching abrasion by means of the wet sand/rubber wheel test. It is the intent of this procedure to provide data that will reproducibly rank materials in their resistance to scratching abrasion under a specified set of conditions.

1.2 Abrasion test results are reported as volume loss in cubic millimeters. Materials of higher abrasion resistance will have a lower volume loss.

1.3 Values stated in SI units are to be regarded as the standard. Inch-pound units are provided for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.02
Developed by Subcommittee: G02.30
Pages: 9
DOI: 10.1520/G0105-02
ICS Code: 83.160.01