Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM G77-98

Standard Test Method for Ranking Resistance of Materials to Sliding Wear Using Block-on-Ring Wear Test

Standard Test Method for Ranking Resistance of Materials to Sliding Wear Using Block-on-Ring Wear Test G0077-98 ASTM|G0077-98|en-US Standard Test Method for Ranking Resistance of Materials to Sliding Wear Using Block-on-Ring Wear Test Standard new BOS Vol. 03.02 Committee G02
$ 83.00 In stock

Scope

1.1 This test method covers laboratory procedures for determining the resistance of materials to sliding wear. The test utilizes a block-on-ring friction and wear testing machine to rank pairs of materials according to their sliding wear characteristics under various conditions.

1.2 An important attribute of this test is that it is very flexible. Any material that can be fabricated into, or applied to, blocks and rings can be tested. Thus, the potential materials combinations are endless. In addition, the test can be run with various lubricants, liquids, or gaseous atmospheres, as desired, to simulate service conditions. Rotational speed and load can also be varied to better correspond to service requirements.

1.3 Wear test results are reported as the volume loss in cubic millimetres for both the block and ring. Materials of higher wear resistance will have lower volume loss.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.02
Developed by Subcommittee: G02.40
Pages: 14
DOI: 10.1520/G0077-98
ICS Code: 77.040.10