Standard Active Last Updated: Dec 06, 2021 Track Document
ASTM G13/G13M-21

Standard Test Method for Impact Resistance of Pipeline Coatings(Limestone Drop Test)

Standard Test Method for Impact Resistance of Pipeline Coatings(Limestone Drop Test) G0013_G0013M-21 ASTM|G0013_G0013M-21|en-US Standard Test Method for Impact Resistance of Pipeline Coatings(Limestone Drop Test) Standard new BOS Vol. 06.02 Committee D01
$ 55.00 In stock

Significance and Use

4.1 This test method is intended to simulate the effects of backfilling after pipe has been placed in the trench. The backfill is often rocky soil and, if it is unscreened and the coated pipe is unshielded by sand or other protective padding, the falling rocks may seriously damage the coating.

Scope

1.1 This test method covers the determination of the relative resistance of pipeline coatings to impact by observing the effects of falling stones on coated pipe specimens.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 06.02
Developed by Subcommittee: D01.48
Pages: 3
DOI: 10.1520/G0013_G0013M-21
ICS Code: 87.040