Standard Historical Last Updated: Mar 04, 2013 Track Document
ASTM G5-94(2011)e1

Standard Reference Test Method for Making Potentiostatic and Potentiodynamic Anodic Polarization Measurements

Standard Reference Test Method for Making Potentiostatic and Potentiodynamic Anodic Polarization Measurements G0005-94R11E01 ASTM|G0005-94R11E01|en-US Standard Reference Test Method for Making Potentiostatic and Potentiodynamic Anodic Polarization Measurements Standard new BOS Vol. 03.02 Committee G01
$ 91.00 In stock

Significance and Use

The availability of a standard procedure, standard material, and a standard plot should make it easy for an investigator to check his techniques. This should lead to polarization curves in the literature which can be compared with confidence.

Samples of a standard ferritic Type 430 stainless steel (UNS S43000) used in obtaining standard reference plot are available for those who wish to check their own test procedure and equipment.

Standard potentiostatic and potentiodynamic polarization plots are supplied with the purchase of the reference material. These reference data are based on the results from different laboratories that followed the standard procedure, using that material in 1.0 N H2SO4. Maximum and minimum current values are shown at each potential to indicate the acceptable range of values.

This test method may not be appropriate for polarization testing of all materials or in all environments.

This test method is intended for use in evaluating the accuracy of a given electrochemical test apparatus, not for use in evaluating materials performance. Therefore, the use of the plots in Figs. 1 and 2 or Appendix X2 is not recommended to evaluate alloys other than Type 430, or lots of Type 430 other than those available through ASTM. The use of the data in this test method in this manner is beyond the scope and intended use of this test method. Users of this test method are advised to evaluate test results relative to the scatter bands corresponding to the particular lot of Type 430 stainless steel that was tested.


CURRENT DENSITY (μA/cm2)

FIG. 1 Typical Standard Potentiostatic Anodic Polarization Plot


CURRENT DENSITY (μA/cm2)

FIG. 2 Typical Standard Potentiodynamic Anodic Polarization Plot

Scope

1.1 This test method covers an experimental procedure for checking experimental technique and instrumentation. If followed, this test method will provide repeatable potentiostatic and potentiodynamic anodic polarization measurements that will reproduce data determined by others at other times and in other laboratories provided all laboratories are testing reference samples from the same lot of Type 430 stainless steel.

1.2 UnitsThe values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.02
Developed by Subcommittee: G01.11
Pages: 12
DOI: 10.1520/G0005-94R11E01
ICS Code: 71.040.50