Standard Historical Last Updated: Dec 08, 2017 Track Document
ASTM G1-03(2011)

Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens

Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens G0001-03R11 ASTM|G0001-03R11|en-US Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens Standard new BOS Vol. 03.02 Committee G01
$ 83.00 In stock

Significance and Use

The procedures given are designed to remove corrosion products without significant removal of base metal. This allows an accurate determination of the mass loss of the metal or alloy that occurred during exposure to the corrosive environment.

These procedures, in some cases, may apply to metal coatings. However, possible effects from the substrate must be considered.

Scope

1.1 This practice covers suggested procedures for preparing bare, solid metal specimens for tests, for removing corrosion products after the test has been completed, and for evaluating the corrosion damage that has occurred. Emphasis is placed on procedures related to the evaluation of corrosion by mass loss and pitting measurements. (WarningIn many cases the corrosion product on the reactive metals titanium and zirconium is a hard and tightly bonded oxide that defies removal by chemical or ordinary mechanical means. In many such cases, corrosion rates are established by mass gain rather than mass loss.)

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 1.1 and 7.2.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.02
Developed by Subcommittee: G01.05
Pages: 9
DOI: 10.1520/G0001-03R11
ICS Code: 77.060