Standard Active Last Updated: Nov 01, 2024 Track Document
ASTM F3231/F3231M-24

Standard Specification for Electrical Systems for Aircraft with Combustion Engine Electrical Power Generation

Standard Specification for Electrical Systems for Aircraft with Combustion Engine Electrical Power Generation F3231_F3231M-24 ASTM|F3231_F3231M-24|en-US Standard Specification for Electrical Systems for Aircraft with Combustion Engine Electrical Power Generation Standard new BOS Vol. 15.09 Committee F44
$ 76.00 In stock
ASTM International

Abstract

This specification applies to the electrical systems aspects of airworthiness and design for "small" aircraft. It establishes the Aircraft Type Code (ATC) compliance matrix based on airworthiness level, number of engines, type of engine(s), stall speed, cruise speed, meteorological conditions, altitude, and maneuvers. An ATC is defined by taking into account both the technical considerations regarding the design of the aircraft and the airworthiness level established based upon risk-based criteria. The requirements established by this specification cover power source capacity and distribution, electrical systems and equipment, storage battery design and installation, circuit protective devices, master switch arrangement, switches, electrical cables and equipment, electrical system fire protection, and electronic equipment.

Scope

1.1 This specification covers electrical systems, electrical equipment, and electrical power distribution aspects of airworthiness and design for aeroplanes with combustion engine generation of electrical power. The material was developed through open consensus of international experts in general aviation. This information was created by focusing on Normal Category Aeroplanes. The content may be more broadly applicable; it is the responsibility of the applicant to substantiate broader applicability as a specific means of compliance.

1.2 An applicant intending to propose this information as Means of Compliance for a design approval shall seek guidance from their respective oversight authority (for example, published guidance from applicable civil aviation authorities (CAAs)) concerning the acceptable use and application thereof. For information on which oversight authorities have accepted this specification (in whole or in part) as an acceptable Means of Compliance to their regulatory requirements (hereinafter “the Rules”), refer to ASTM Committee F44 web page (www.astm.org/COMMITTEE/F44.htm). Annex A1 maps the Means of Compliance described in this specification to EASA CS-23, amendment 5, or later, and FAA 14 CFR Part 23, amendment 64, or later.

1.3 Units—This standard may present information in either SI units, English Engineering units, or both; the values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.09
Developed by Subcommittee: F44.50
Pages: 15
DOI: 10.1520/F3231_F3231M-24
ICS Code: 49.020