Standard Active Last Updated: Mar 06, 2019 Track Document
ASTM F2878-19

Standard Test Method for Protective Clothing Material Resistance to Hypodermic Needle Puncture

Standard Test Method for Protective Clothing Material Resistance to Hypodermic Needle Puncture F2878-19 ASTM|F2878-19|en-US Standard Test Method for Protective Clothing Material Resistance to Hypodermic Needle Puncture Standard new BOS Vol. 11.03 Committee F23
$ 69.00 In stock

Significance and Use

5.1 This test method evaluates puncture resistance of protective clothing materials which may include: plastics or elastomeric films, coated fabrics, flexible materials, laminates, leathers, or textile materials.

5.1.1 This test method uses hypodermic needles with specified dimensions as puncture probes.

5.1.2 This test method evaluates needle puncture resistance of protective clothing materials, perpendicular to the material’s surface and with no supporting structure under/behind the material specimen.

5.1.3 Evaluation of puncture resistance for snag-type puncture should be performed in accordance with Test Method D2582.

5.1.4 Evaluation of puncture resistance for non-cutting puncture should be performed in accordance with Test Method F1342/F1342M.

Abstract

This test method is used for determining the force required to cause a hypodermic needle to penetrate through protective clothing material. It defines three common hypodermic needles - 21-, 25-, 28- gauge needles - to evaluate puncture resistance of protective clothing. This test method does not attempt to simulate all use conditions. A number of variables which impact puncture resistance, such as stiffness of backing materials, presence of lubricants, and tension on the specimen, are not addressed by this test method.

Scope

1.1 This test method is used to determine the force required to cause a sharp-edged hypodermic needle to penetrate through protective clothing material. The standard describes three needles that may be used: 21-, 25-, or 28-gauge needles.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 11.03
Developed by Subcommittee: F23.20
Pages: 6
DOI: 10.1520/F2878-19
ICS Code: 13.340.10