Standard Active Last Updated: Mar 08, 2024 Track Document
ASTM F2623-24e1

Standard Specification for Polyethylene of Raised Temperature (PE-RT) Systems for Non-Potable Water Applications

Standard Specification for Polyethylene of Raised Temperature (PE-RT) Systems for Non-Potable Water Applications F2623-24E01 ASTM|F2623-24E01|en-US Standard Specification for Polyethylene of Raised Temperature (PE-RT) Systems for Non-Potable Water Applications Standard new BOS Vol. 08.04 Committee F17
$ 69.00 In stock
ASTM International


This specification establishes the basic requirements and corresponding test methods for polyethylene of raised temperature (PE-RT) SDR 9 tubing that is outside diameter controlled, and pressure rated for water at specific temperatures. The tubing produced under this specification shall be permitted for use in general fluid transport, including hydronics and irrigations systems. The plastic used to make the tubing shall be virgin plastic or reworked plastic and shall have Plastics Pipe Institute (PPI) long-term hydrostatic design stress and pressure ratings as the specified temperatures. When evaluated by the test procedures provided herein, the tubing shall meet specified requirements for workmanship, dimensions such as outside diameter and wall thickness, sustained pressure, burst pressure, oxidative resistance, and bent tubes. Quality assurance and product marking methods are also considered.


1.1 This specification establishes requirements for polyethylene of raised temperature (PE-RT) systems for non-potable water applications. System components include PE-RT SDR 9 tubing, manifolds, fittings, valves and other appurtenances, and mechanical and fusion joining. PE-RT tubing is pressure rated for water at 73 °F (23 °C) and 180 °F (82 °C), and optionally 140 °F (60 °C). Included are requirements for materials, workmanship, dimensions and tolerances, product tests, and markings, and an optional barrier layer. Fittings include mechanical insert fittings and fusion fittings.

1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3.1 Values in parentheses are appropriately rounded for accuracy and precision and are not exact equivalents.

1.4 The tubing systems produced under this specification are intended for use in the transport of non-potable water such as hydronic and irrigation systems.

1.4.1 PE-RT tubing containing an outside surface or mid-wall gas barrier layer or both is acceptable.

1.4.2 PE-RT systems under this standard are not intended for use in the transport of potable water. See Specification F2769 for PE-RT potable water distribution systems.

1.5 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 08.04
Developed by Subcommittee: F17.26
Pages: 12
DOI: 10.1520/F2623-24E01
ICS Code: 23.040.20