Standard Historical Last Updated: Aug 16, 2017
ASTM F2590-06

Standard Specification for Bearing, Roller, Thrust, Two Channeled Race Surface, Rigid or Flat Seat Type


1.1 This specification covers requirements for rigid or flat seat type, two channeled race surface, thrust roller bearings.

1.2 Intended UseThe bearings covered in this specification are intended for use in slow rotating or oscillating applications where pure thrust loads are applied.

1.3 This specification contains many of the requirements of MS17169, which was originally developed by the Department of Defense and maintained by the Defense Supply Center in Richmond. The following government activity codes may be found in the Department of Defense, Standardization Directory SD-1.

Preparing ActivityCustodiansReview Activities
Navy-MCAir Force-84
Air Force-99

1.4 For design feature purposes, this specification takes precedence over procurement documents referenced herein.

1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 01.09
Developed by Subcommittee: F34.04
Pages: 4
DOI: 10.1520/F2590-06
ICS Code: 21.100.20