Standard Active Last Updated: Sep 09, 2024 Track Document
ASTM F2465/F2465M-24

Standard Guide for Oil Spill Dispersant Application Equipment: Single-point Spray Systems

Standard Guide for Oil Spill Dispersant Application Equipment: Single-point Spray Systems F2465_F2465M-24 ASTM|F2465_F2465M-24|en-US Standard Guide for Oil Spill Dispersant Application Equipment: Single-point Spray Systems Standard new BOS Vol. 11.08 Committee F20
$ 61.00 In stock
ASTM International

Abstract

This guide covers performance criteria, requirements, material characteristics, and essential features for oil spill dispersant application systems. This guide also covers vessel-based spray systems employing single-point spray nozzles. Oil spill dispersant spray equipment shall conform to the minimum performance requirements such as target dosage, dispersant flow or injection rate determination, droplet size distribution, and maximum delivery variation over spray switch. Materials used in the spray systems shall be corrosion-resistant to salt water and shall be able to be used or stored at extreme temperatures. Performance data shall be provided to user, including information such as dilute versus neat application, dosage chart, accuracy of data, nozzles and pumps, and operational manual.

Scope

1.1 This guide covers performance criteria, requirements, material characteristics, and essential features for oil spill dispersant application systems. This guide is not intended to be restrictive to a specific configuration.

1.2 This guide covers vessel-based spray systems employing single-point spray nozzles, including designs that have been based on or evolved from “fire-monitor” systems, and is not fully applicable to other systems such as spray boom/nozzle or aircraft systems.

1.3 This guide is one of five related to dispersant application systems. The other four guides cover the design of boom and nozzle systems, spray system calibration, spray deposition measurements, and use of the systems. Familiarity with all five guides (listed in 2.1) is recommended.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 11.08
Developed by Subcommittee: F20.13
Pages: 4
DOI: 10.1520/F2465_F2465M-24
ICS Code: 13.020.40