Standard Historical Last Updated: Oct 09, 2019 Track Document
ASTM F2369-19

Standard Safety Specification for Non-Integral Firearm Locking Devices

Standard Safety Specification for Non-Integral Firearm Locking Devices F2369-19 ASTM|F2369-19|en-US Standard Safety Specification for Non-Integral Firearm Locking Devices Standard new BOS Vol. 15.11 Committee F15
$ 83.00 In stock

Scope

1.1 This specification covers non-integral firearm locking devices used to deter unauthorized use of unloaded firearms. These devices can be mechanical, electromechanical, or a combination thereof.

1.2 This specification contains functional, operational, and safety requirements for non-integral firearm locking devices.

1.3 The specification is intended to apply only to non-integral locks or locking mechanisms applied to, in, around, or about a firearm, either external to the firearm or by some method of introduction to or within the firearm. The specification is not intended to set evaluation standards by which safety levers, firing pin blocks, or other traditional discharge prevention mechanisms are evaluated, notwithstanding the fact that these mechanisms may prevent inadvertent discharge. This specification is not applicable to devices used for, or intended for, the prevention of theft or other intentional misuse of firearms.

Note 1: Tests described are laboratory type tests and although they may simulate some field conditions, they do not duplicate all field conditions.

Note 2: There is no apparent comparable ISO/IEC standard.

1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.5 The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.11
Developed by Subcommittee: F15.53
Pages: 15
DOI: 10.1520/F2369-19
ICS Code: 95.060