Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM F1967-07a

Standard Consumer Safety Specification for Infant Bath Seats

Standard Consumer Safety Specification for Infant Bath Seats F1967-07A ASTM|F1967-07A|en-US Standard Consumer Safety Specification for Infant Bath Seats Standard new BOS Vol. 15.11 Committee F15
$ 83.00 In stock

Scope

1.1 This consumer safety specification establishes performance requirements, test methods, and labeling requirements to promote the safe use of infant bath seats. Products commonly referred to as bath rings also are included in the scope of this specification. Traditional infant bath tubs that are used to bathe an infant are not within the scope of this standard.

1.2 This consumer safety specification is intended to reduce the risk of death and minimize injury to infants resulting from use and reasonably foreseeable abuse of infant bath seats.

1.3 No infant bath seat produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.

1.4 The test values and dimensions stated in inch-pound units are to be regarded as standard. SI values in parentheses are given for information only.

The following precautionary caveat pertains only to the test methods portion, Section 7, of this consumer safety specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.11
Developed by Subcommittee: F15.20
Pages: 13
DOI: 10.1520/F1967-07A
ICS Code: 97.140; 97.190