Standard Historical Last Updated: Nov 22, 2011 Track Document
ASTM F1914-07

Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering

Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering F1914-07 ASTM|F1914-07|en-US Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering Standard new BOS Vol. 15.04 Committee F06
$ 83.00 In stock

Significance and Use

The indentation and the residual indentation of resilient floor covering is important since the resistance and recovery from indentation reflects on the ability of the resilient floor covering to perform properly after installation.

The indentation of a resilient floor covering shall be measured using a specified type of indentor, flat or spherical, under a specified load and time.

The residual indentation of a resilient floor covering shall be measured after a specified recovery time.

See Table 1 for detailed testing and conditioning requirements by products (specification) type.

Scope

1.1 This test method covers procedures to determine short-term indentation and residual indentation of resilient flooring, when subjected to concentrated loads.

1.2 The test methods appear in the following order:

Section
Indentation by McBurney Test4 to 10
Indentation and Residual Indentation11 to 15

1.3 There are two procedures with their respective apparatus. The first (McBurney Test) is described in Sections 4 to 10 and is restricted to a spherical foot. It is only used for initial indentation measurements of VCT. The second is described in Sections 11 to 15 and has interchangeable feet with variable geometry. It is used to measure initial and residual indentation.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.04
Developed by Subcommittee: F06.30
Pages: 5
DOI: 10.1520/F1914-07
ICS Code: 97.150