Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM F1290-98a

Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings

Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings F1290-98A ASTM|F1290-98A|en-US Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings Standard new BOS Vol. 08.04 Committee F17
$ 73.00 In stock

Scope

1.1 This practice describes general procedures for making joints with polyolefin pipe and fittings by means of electrofusion joining techniques. These should be regarded as general procedures and not as a substitute for the installation procedures specified by the manufacturers. Manufacturers should be requested to supply specific recommendations for joining their products.

Note 1-Reference to the manufacturer in this practice is defined as the electrofusion fitting manufacturer.

1.2 The techniques covered are applicable only to joining polyolefin pipe and fittings of related polymer chemistry, for example, polyethylenes to polyethylenes using a polyethylene electrofusion fitting. Consult the manufacturer's recommendations for compatibility of the electrofusion fitting with the specific pipe or fitting material to be joined.

1.3 The electrofusion joining technique described can produce sound joints between polyolefin pipe and fittings, provided that all products involved (that is, pipe and fittings) meet the appropriate ASTM specifications.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.04
Developed by Subcommittee: F17.20
Pages: 3
DOI: 10.1520/F1290-98A
ICS Code: 23.040.20; 23.040.45