Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM F1247-89(1996)e1

Standard Specification for Intrusion Resistant Generic Vault Structures

Standard Specification for Intrusion Resistant Generic Vault Structures F1247-89R96E01 ASTM|F1247-89R96E01|en-US Standard Specification for Intrusion Resistant Generic Vault Structures Standard new BOS Vol. 15.08 Committee F12
$ 83.00 In stock

Scope

1.1 This specification is for the use and guidance of those who purchase, design, construct, install, approve, or modify generic vault structures intended for protection of valuables against loss due to forced entry.

1.2 This specification includes the descriptions of terms, classifications, materials, practices, and methods to be followed in constructing, fabricating, or modifying intrusion resistant generic vaults.

1.3 This specification does not address fire resistivity, nor does it address modular panels.

1.4 This specification is not intended to prevent the use of systems, methods, or devices that provide a level of intrusion resistance equivalent or better than that prescribed herein. Any system, method, or device different from that detailed herein may be examined, in accordance with the intent of this specification, and if found to be equivalent or better, may be included.

1.5 Nothing in this specification shall be construed to prohibit better or safer conditions than the requirements specified herein.

1.6 Materials and construction details outlined in this specification are intended to detail protective requirements necessary to achieve the required level of intrusion resistance, and are not intended to address structural soundness or operational fitness, areas for which the project engineer, architect, or equipment supplier are responsible.

1.7 Each referenced document cited in Section 2 shall be meant to be the edition in effect on the date this specification was published.

Note 1-A rationale is given in Appendix XI.

1.8 The values stated in inch-pound units are to be regarded as the standard. The SI values in parentheses are given for information purposes only.

1.9 The following precautionary statement pertains to the test method portion only, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.08
Developed by Subcommittee: F12.10
Pages: 8
DOI: 10.1520/F1247-89R96E01
ICS Code: 13.310