Standard Historical Last Updated: Aug 16, 2017
ASTM F1200-88(1998)

Standard Specification for Fabricated (Welded) Pipe Line Strainers (Above 150 psig and 150&#176F)

Standard Specification for Fabricated (Welded) Pipe Line Strainers (Above 150 psig and 150°F)
$ 60.00 In stock


1.1 This specification covers welded strainers in services above 150 psig or 150°F (1 MPa and 65°C). For welded strainers in services at or below these ratings and cast strainers, see Specification F1199.

1.2 This specification provides the minimum requirements for the design fabrication, rating, marking, and testing of welded pipe line strainers for services above 0°F (-18°C).

1.3 Strainers manufactured to this specification are acceptable for use in the marine environment.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 01.07
Developed by Subcommittee: F25.11
Pages: 4
DOI: 10.1520/F1200-88R98
ICS Code: 23.040.01