Standard Active Last Updated: Jun 03, 2024 Track Document
ASTM F1144-19(2024)

Standard Specification for Manhole Cover Assembly, Bolted, Semi-Flush, Oiltight and Watertight, Hinged

Standard Specification for Manhole Cover Assembly, Bolted, Semi-Flush, Oiltight and Watertight, Hinged F1144-19R24 ASTM|F1144-19R24|en-US Standard Specification for Manhole Cover Assembly, Bolted, Semi-Flush, Oiltight and Watertight, Hinged Standard new BOS Vol. 01.07 Committee F25
$ 69.00 In stock
ASTM International

Abstract

This specification covers the requirements for the design and construction of a semi-flush, oiltight, and watertight bolted hinged manhole cover assembly for use in deck or bulkheads subjected to lateral pressures such as resulting from vehicle loads or hydrostatic pressure. Not covered by this specification are the design requirements for manhole cover assembly subjected to primary or cyclic loads and certain hazardous cargos. The manhole cover assembly covered by this specification are classified into various types (Types I and II based on size of access opening), grades (Grades 1-3 based on the thickness of the cover plate), and classes (Classes A and B based on surface finish). The assembly shall be comprised of covers, mounting rings, gaskets, studs, washers, hinge assemblies, and nuts. The components shall be manufactured from carbon structural steel (plate for the cover, ring, hinge pad, and hinge blade), steel (round bar for hinge pin), ordinary steel (welded studs), and yellow brass (washers, heavy hex nuts, and cotter pin). The assembly shall be free of splinters, sharp edges, burrs, projections, and weld splatters, and shall have a Class A finish. Pressure and tightness tests shall be performed and shall conform to the requirements specified.

Scope

1.1 This specification provides design and construction criteria for a semi-flush, oiltight and watertight bolted hinged manhole cover assembly.

1.2 The manhole cover assemblies depicted on this specification are for use in decks or bulkheads requiring oiltight and watertight covers that are not required to be completely flush. Manhole cover assemblies shall be complete with covers, mounting rings, gaskets, studs, washers, hinge assemblies, and nuts.

1.3 Handles, if required, shall be as specified in the ordering information.

1.4 Values stated in inch-pound units are to be regarded as standard.

1.5 This standard is not applicable to certain hazardous cargos. (See 46 CFR 153.254 and 46 CFR 154.340.)

1.6 This specification provides design and construction for manhole cover assemblies subjected to lateral pressures such as resulting from vehicle loads or hydrostatic pressures. Where manhole cover assemblies are subjected to primary or cyclic loads, other reinforcement or construction criteria may be necessary to integrate the manhole assembly with the required structural reinforcement for openings in decks or bulkheads. Design of the manhole cover assembly for primary or cyclic loads is beyond the scope of this specification.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.07
Developed by Subcommittee: F25.03
Pages: 7
DOI: 10.1520/F1144-19R24
ICS Code: 47.020.10