Standard Active Last Updated: Jun 03, 2024 Track Document
ASTM F1143-19(2024)

Standard Specification for Manhole Cover Assembly, Bolted, Raised, Oiltight and Watertight

Standard Specification for Manhole Cover Assembly, Bolted, Raised, Oiltight and Watertight F1143-19R24 ASTM|F1143-19R24|en-US Standard Specification for Manhole Cover Assembly, Bolted, Raised, Oiltight and Watertight Standard new BOS Vol. 01.07 Committee F25
$ 63.00 In stock
ASTM International

Abstract

This specification provides the design and construction criteria for bolted oiltight and watertight manhole cover assemblies that are subjected to lateral pressures such as resulting from vehicle loads or hydrostatic pressures, and used in decks or bulkheads in which the assembly must be of the raised type. Manhole covers shall be complete with coaming, gasket, welded studs or bolts, washers, and nuts. This specification does not address certain hazardous cargos, as well as the design of the manhole cover assembly for primary or cyclic loads.

Scope

1.1 This specification provides design and construction criteria for a raised, bolted, oiltight and watertight manhole cover assembly.

1.2 The manhole cover assemblies depicted in this specification are for use in decks or bulkheads in which the manhole cover assemblies must be of the raised type. Manhole cover shall be complete with coaming, gasket, welded studs or bolts, washers, and nuts.

1.3 Determination of the use of handles will be as specified in the ordering information.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This specification is not applicable to certain hazardous cargos (see 46 CFR 153.254 and 46 CFR 154.340).

1.6 This specification provides design and construction for manhole cover assemblies subjected to lateral pressures such as resulting from vehicle loads or hydrostatic pressures. Where manhole cover assemblies are subjected to primary or cyclic loads, other reinforcement or construction criteria may be necessary to integrate the manhole assembly with the required structural reinforcement for openings in decks or bulkheads. Design of the manhole cover assembly for primary or cyclic loads is beyond the scope of this specification.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.07
Developed by Subcommittee: F25.03
Pages: 8
DOI: 10.1520/F1143-19R24
ICS Code: 47.020.10