Standard Withdrawn, No replacement   Last Updated: Oct 07, 2013 Track Document
ASTM F991M-12

Standard Specification for Docking/Drain Plug and Boss Assemblies [Metric] (Withdrawn 2013)

Standard Specification for Docking/Drain Plug and Boss Assemblies [Metric] (Withdrawn 2013) F0991M-12 ASTM|F0991M-12|en-US Standard Specification for Docking/Drain Plug and Boss Assemblies [Metric] (Withdrawn 2013) Standard new BOS Vol. 01.07 Committee F25
$ 0.00 Out of stock

Abstract

This specification provides design, construction, and purchasing criteria for docking/drain plug and boss assemblies. Assemblies are intended for installation in shell, rudder, and tank bottom plate. Assemblies shall be installed at the lowest point of a tank or rudder for draining during dry docking. Docking plugs and bosses shall be classified as follows: type I - docking plug and bosses for plating from 8 to 15 mm, and type II - docking plug and bosses for plating greater than 15 to 38 mm. The procedure for installing docking/drain plug and boss assemblies are presented.

Scope

1.1 This specification provides design, construction, and purchasing criteria for docking/drain plug and boss assemblies.

1.2 Assemblies are intended for installation in shell, rudder, and tank bottom plate from 8 through 38 mm.

1.3 Assemblies shall be installed at the lowest point of a tank or rudder for draining during dry docking.

1.4 The values stated in SI units are to be regarded as the standard.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center