Standard Historical Last Updated: Mar 27, 2020 Track Document
ASTM F899-19

Standard Specification for Wrought Stainless Steels for Surgical Instruments

Standard Specification for Wrought Stainless Steels for Surgical Instruments F0899-19 ASTM|F0899-19|en-US Standard Specification for Wrought Stainless Steels for Surgical Instruments Standard new BOS Vol. 13.01 Committee F04
$ 83.00 In stock

Abstract

This specification covers the chemical requirements for wrought stainless steels used for the manufacture of surgical instruments. Classes of stainless steels covered here are Class 3 (austenitic stainless steel), Class 4 (martensitic stainless steel), Class 5 (precipitation hardening stainless steel), and Class 6 (ferritic stainless steel). The data contained in this specification, such as typical hardness values, common heat treating cycles, and examples of selected stainless steels that have been used for surgical instruments, are provided for reference only. Mechanical property, heat treatment, hardness, and all other requirements except for chemical composition, are governed by the appropriate material standards as specified or as agreed upon between purchaser and supplier.

Scope

1.1 This specification covers the chemistry requirements for wrought stainless steels used for the manufacture of surgical instruments. The data contained in Tables 1-4 of this specification, including typical hardness values, common heat treating cycles, and examples of selected stainless steels that have been used for surgical instruments, is provided for reference only. Mechanical property requirements, heat treating requirements, hardness requirements and all other requirements except chemistry are governed by the appropriate material standards as referenced below or as agreed upon between the purchaser and supplier.

1.2 The SI units in this standard are the primary units. The values stated in either primary SI units or secondary inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of each other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 13.01
Developed by Subcommittee: F04.12
Pages: 8
DOI: 10.1520/F0899-19
ICS Code: 11.040.30