Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM F725-03e1

Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards

Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards F0725-03E01 ASTM|F0725-03E01|en-US Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards Standard new BOS Vol. 08.04 Committee F17
$ 66.00 In stock

Significance and Use

This practice is used for drafting impact test specification requirements, and it presupposes no special familiarity with statistical methods. It provides for specification values that will pass acceptable lots with a high degree of certainty. The impact test requirement is intended to discriminate between acceptable materials and manufacturing methods and those which are not; it is not a simulated service test.

Scope

1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D 2444.

1.2 This practice is applicable to thermoplastic pipe and fittings.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.04
Developed by Subcommittee: F17.40
Pages: 4
DOI: 10.1520/F0725-03E01
ICS Code: 23.040.20; 23.040.45