Standard Active Last Updated: Jan 24, 2024 Track Document
ASTM F708-24

Standard Practice for Design and Installation of Rigid Pipe Hangers

Standard Practice for Design and Installation of Rigid Pipe Hangers F0708-24 ASTM|F0708-24|en-US Standard Practice for Design and Installation of Rigid Pipe Hangers Standard new BOS Vol. 01.07 Committee F25
$ 76.00 In stock
ASTM International

Abstract

This practice covers acceptable methods of fabricating and installing rigid pipe hangers used to support shipboard piping systems, it provides guidance for the design of hanger caps, straps and standoffs, selection of hanger and hanger liner materials, hanger bolting, and hanger spacing. The pipe hanger style includes: split cap hanger, 3strap hanger, welded hanger, U-bolt hanger, J band type hanger, Nelson hanger, clamp hanger assembled with mounting channel, poly-block twin clamp hanger, crimp-on weld stud-type hangers, banded weld stud-type hanger, and poly-block single-clamp hanger. Guidance in determining pipe hanger spacing are provided. Special consideration should be given to areas of concentrated loads, such as risers, valves, or groups of fittings, and to piping configurations that could create rotational forces. Hangers need not be lined unless the hanger and pipe are of dissimilar material. All hanger bolts within tanks or other inaccessible areas shall be secured with lock nuts, lock washers, or by some other means. Pipe hangers and standoffs located in areas subject to corrosion, such as in bilges, ballast tanks, and areas exposed to the weather, should be zinc-plated or blasted and coated with inorganic zinc or coated with the same material as that of the surrounding area. Standoffs fabricated from pipe should not be used within tanks. Consideration should be given to thermal growth of the piping when selecting or locating hangers so as not to overstress the piping or hangers.

Scope

1.1 This practice covers acceptable methods of fabricating and installing rigid pipe hangers used to support shipboard piping systems with temperatures of 650 °F (343 °C) or less.

1.2 This practice provides guidance for the design of hanger caps, straps and standoffs, selection of hanger and hanger liner materials, hanger bolting, and hanger spacing.

1.3 Other hanger designs may be used provided they result in an adequately supported vibration-free piping system and are compatible with the intended system service and temperature limitations.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 01.07
Developed by Subcommittee: F25.11
Pages: 12
DOI: 10.1520/F0708-24
ICS Code: 21.060.70