Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM F37-00

Standard Test Methods for Sealability of Gasket Materials

Standard Test Methods for Sealability of Gasket Materials F0037-00 ASTM|F0037-00|en-US Standard Test Methods for Sealability of Gasket Materials Standard new BOS Vol. 09.02 Committee F03
$ 75.00 In stock


1.1 These test methods provide a means of evaluating the sealing properties of sheet and solid form-in-place gasket materials at room temperature. Test Method A is restricted to liquid leakage measurements, whereas Test Method B may be used for both liquid and gas leakage measurements.

1.2 These test methods are suitable for evaluating the sealing characteristics of a gasket material under different compressive flange loads. The test method may be used as an acceptance test when the supplier and the purchaser have agreed to specific test conditions for the following parameters: test medium, internal pressure on medium, and flange load on gasket specimens.

1.3 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For specific hazard statements, see Section 6, Note 3, and Note 8.)

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 09.02
Developed by Subcommittee: F03.10
Pages: 7
DOI: 10.1520/F0037-00
ICS Code: 23.100.60; 73.080