Standard Active Last Updated: Mar 29, 2024 Track Document
ASTM E3385-24

Standard Practice for On-Site Inspection of Fire Resistive Duct Systems

Standard Practice for On-Site Inspection of Fire Resistive Duct Systems E3385-24 ASTM|E3385-24|en-US Standard Practice for On-Site Inspection of Fire Resistive Duct Systems Standard new BOS Vol. 04.12 Committee E06
$ 63.00 In stock
ASTM International

Significance and Use

5.1 This practice provides a standard set of procedures that are to be followed when conducting and reporting on inspections of installed fire resistive duct systems.

5.2 This practice provides a means to verify compliance of the installed fire resistive duct system to the inspection document.

5.3 This practice does not provide a basis for selecting a design listing, the installation contractor, products, or any other material, service, or company.

5.4 This practice does not establish any performance criteria of the inspected fire resistive duct systems.


1.1 This practice covers a standard set of procedures for inspecting and reporting on the installed fire resistive duct systems.

1.2 This practice establishes procedures to inspect products and systems, including methods for field verification and inspection.

1.3 This practice provides an inspector and inspection body, various methods to verify that required systems have been installed in accordance with the inspection document.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 04.12
Developed by Subcommittee: E06.21
Pages: 7
DOI: 10.1520/E3385-24
ICS Code: 13.220.50; 91.140.30