Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM E2561-07

Standard Practice for Installation of Inductive Loop Detectors

Standard Practice for Installation of Inductive Loop Detectors E2561-07 ASTM|E2561-07|en-US Standard Practice for Installation of Inductive Loop Detectors Standard new BOS Vol. 04.03 Committee E17
$ 91.00 In stock

Scope

1.1 This practice describes the recommended procedure for installing inductive loop detectors in sawed slots in roadway pavement for use as a traffic monitoring device or to actuate traffic control devices such as a traffic signal. Although the practice is not intended for installing preformed loops, the practice does contain information of value for this type of loop such as recommendations for the number of turns of loop wire, number and direction of twists in the lead-in wire and cable, splice location (if needed), and grounding options.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.03
Developed by Subcommittee: E17.52
Pages: 14
DOI: 10.1520/E2561-07
ICS Code: 93.080.30