Standard Active Last Updated: Apr 16, 2024 Track Document
ASTM E1729-24

Standard Practice for Field Collection of Dried Paint Samples for Subsequent Lead Determination

Standard Practice for Field Collection of Dried Paint Samples for Subsequent Lead Determination E1729-24 ASTM|E1729-24|en-US Standard Practice for Field Collection of Dried Paint Samples for Subsequent Lead Determination Standard new BOS Vol. 11.07 Committee D22
$ 63.00 In stock
ASTM International

Significance and Use

5.1 Although this practice is intended for the collection of dried paint samples in and around buildings and related structures for the subsequent determination of lead content, this practice may also be used to collect paint samples from other structures for lead analysis.3

5.2 The variability associated with the sampling of dried paint is generally considered to be far higher than the variability associated with the analyses of the paint specimens. Therefore, it is essential that sample collection be properly controlled to produce representative and meaningful samples.

5.3 These samples are collected in a manner that will permit subsequent digestion using sample preparation techniques such as Practices E1645 or E1979 and determination of lead using laboratory analysis techniques such as inductively coupled plasma atomic emission spectrometry (ICP-AES) (see Test Method E3203) or flame atomic absorption spectrometry (FAAS) (see Test Method E3193).


1.1 This practice covers the collection of samples of dried paint and other coatings from buildings and related structures.

1.2 This practice is used to collect samples for subsequent determination of lead on an area basis (milligrams of lead per area sampled) or concentration basis (milligrams of lead per gram of dried paint collected or mass percent of lead in the paint sample collected).

1.3 This practice does not address the sampling design criteria (that is, a sampling plan that includes the number and location of samples) that are used for risk assessment and other lead hazard activities. See Guide E2115 or Practices E2271/E2271M or E3074/E3074M.

1.4 This practice contains notes that are explanatory and are not part of the mandatory requirements of this practice.

1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. A specific warning statement is given in

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 11.07
Developed by Subcommittee: D22.12
Pages: 5
DOI: 10.1520/E1729-24
ICS Code: 87.040