Standard Historical
Active: ASTM E1274-18
Last Updated: Dec 31, 2010 Track Document
ASTM E1274-03

Standard Test Method for Measuring Pavement Roughness Using a Profilograph

Standard Test Method for Measuring Pavement Roughness Using a Profilograph E1274-03 ASTM|E1274-03|en-US Standard Test Method for Measuring Pavement Roughness Using a Profilograph Standard new BOS Vol. 04.03 Committee E17
$ 66.00 In stock

Significance and Use

This test method provides a means for measuring the roughness of new or rehabilitated pavements. Results may differ between profilographs of different designs and therefore will not necessarily agree with roughness measurements by other profilographs or other roughness-measuring equipment.

Scope

1.1 This test method covers the measurement of pavement roughness using an articulated multi-wheeled profilograph at least 23 ft (7 m) long (Fig. 1 is typical).

1.2 This test method utilizes a surface record made by moving the profilograph longitudinally over the pavement at less than 3 mph (5 km/hr). The record is analyzed to determine the rate of roughness and to identify bumps that exceed a specified threshold.

1.3 The values stated in inch-pound units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 6 for specific hazard statement.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.03
Developed by Subcommittee: E17.31
Pages: 4
DOI: 10.1520/E1274-03
ICS Code: 93.080.20