Standard Active Last Updated: Nov 12, 2018 Track Document
ASTM E959-83(2018)

Standard Test Method for Characterizing the Performance of Refuse Size-Reduction Equipment

Standard Test Method for Characterizing the Performance of Refuse Size-Reduction Equipment E0959-83R18 ASTM|E0959-83R18|en-US Standard Test Method for Characterizing the Performance of Refuse Size-Reduction Equipment Standard new BOS Vol. 11.04 Committee D34
$ 63.00 In stock

Significance and Use

5.1 Throughput, power and energy requirements, and product size are key parameters that describe the operation and performance of solid waste size-reduction equipment.

5.2 This test method can be used to determine if the size-reduction equipment is operating within specifications and meeting performance criteria.

5.3 Having determined the parameters given in 5.1, the equipment that has been subjected to the test may be compared to other equipment similarly tested in order to establish relative levels of performance among equipment.

5.4 The basic test period is a continuous 2 to 4-h duration. The use of several test periods may be warranted to adequately assess the performance of size-reduction equipment.

Scope

1.1 This test method covers measuring the performance of solid waste size-reduction equipment.

1.2 This test method can be used to measure the flow (that is, throughput) of solid waste through the size-reduction equipment, energy usage of the size-reduction device, and particle size of the shredded product.

1.3 This test method includes instructions for measuring energy usage, solid waste throughput, net processing time, and particle size distribution.

1.4 This test method applies only to size-reduction equipment that produces a shredded product with a size corresponding to 90 % cumulative passing in the range of 0.5 to 15 cm (0.2 to 6 in.) on an air-dry weight basis. For material with nominal sizes outside of this range, the precision and bias statements for particle size designation (Section 14) may not apply.

1.5 This test method can be applied to size-reduction equipment located anywhere within a processing line.

1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6.1 Exception—The values given in parentheses are for information only.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See Section 7 for specific hazard information.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 11.04
Developed by Subcommittee: D34.03
Pages: 9
DOI: 10.1520/E0959-83R18
ICS Code: 13.030.40