Standard Withdrawn, No replacement   Last Updated: Dec 31, 2010 Track Document
ASTM E713-88(2002)

Standard Guide for Selection of Scales for Metric Building Drawings (Withdrawn 2010)

Standard Guide for Selection of Scales for Metric Building Drawings (Withdrawn 2010) E0713-88R02 ASTM|E0713-88R02|en-US Standard Guide for Selection of Scales for Metric Building Drawings (Withdrawn 2010) Standard new BOS Vol. 04.11 Committee E06
$ 0.00 Out of stock

Abstract

This guide specifies recommended scales for architectural, building product, and building drawings using metric (SI) units of measurement, and measured with scale instruments graduated in millimetres. Careful consideration should be given to the selection of suitable scales in metric building drawings. Scales for use with metric (SI) drawings are expressed as ratios only. For the purpose of classifying suitable scale ratios, the following drawing types shall be identified: area location plan; block plan; site plans; general location drawings; component drawings; assembly drawings; and component detail drawings.

Scope

1.1 This guide specifies recommended scales for architectural, building product, and building drawings using metric (SI) units of measurement, and measured with scale instruments graduated in millimetres. Preferred scales are listed for various types of drawings.

Language unavailable
Format unavailable
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center