Standard Active Last Updated: Jul 06, 2017 Track Document
ASTM E650/E650M-17

Standard Guide for Mounting Piezoelectric Acoustic Emission Sensors

Standard Guide for Mounting Piezoelectric Acoustic Emission Sensors E0650_E0650M-17 ASTM|E0650_E0650M-17|en-US Standard Guide for Mounting Piezoelectric Acoustic Emission Sensors Standard new BOS Vol. 03.03 Committee E07
$ 55.00 In stock

Significance and Use

4.1 The methods and procedures used in mounting AE sensors can have significant effects upon the performance of those sensors. Optimum and reproducible detection of AE requires both appropriate sensor-mounting fixtures and consistent sensor-mounting procedures.


1.1 This document provides guidelines for mounting piezoelectric acoustic emission (AE) sensors.

1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Contact Sales
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Book of Standards Volume: 03.03
Developed by Subcommittee: E07.04
Pages: 4
DOI: 10.1520/E0650_E0650M-17
ICS Code: 17.140.01